HEIDENHAIN MANUALPLUS 4110 Manual page 2

This manual is intended to improve your operation and programming of the MANUALplus 4110.
By way of examples, the setup of the lathe, the description and measurement of tools, and the
creation of cycle programs and ICP contours are explained step by step.
These examples were created with NC software 507 807-xx.
© 2004 Dr. JOHANNES HEIDENHAIN GmbH
All texts, pictures and graphics, as well as any parts thereof, are copyrighted material. They may
only be copied and printed for private, scientific and non-commercial informative purposes,
and only if they include this copyright notice. Dr. JOHANNES HEIDENHAIN GmbH reserves the
right to revoke this permission at any time. Without obtaining written permission in advance from
Dr. JOHANNES HEIDENHAIN GmbH, the texts, pictures and graphics may not be duplicated,
archived, stored on a server, included in newsgroups, used in online services, saved on
CD-ROMs or printed in publications. The unlawful duplication and/or dissemination of the
copyrighted texts, pictures and graphics will be prosecuted according to civil and criminal law.