Create The “Matrix” Cycle Program; “Matrix” Example Program - HEIDENHAIN MANUALPLUS 4110 Manual

Create the "Matrix" cycle program
"Matrix" example program
This example illustrates transverse machining. (It is assumed that the reader is familiar with steps
explained in the previous example.)
Prerequisites:
The workpiece blank is clamped
The roughing tool T1 is clamped
The roughing tool T1 and finishing tool T6 is defined and measured
The workpiece datum is defined
The tool change point is defined
The protection is defined and activated
The maximum shaft speed is defined
HEIDENHAIN MANUALplus 4110 Surface Machining Example 8.1