HEIDENHAIN MANUALPLUS 4110 Manual page 117

Create the "Matrix" ICP contour
Contour element 5 (oblique cut)

Switch to line entry:
Press the Line soft key

Press the Line menu key
Describe the contour element:

Target point X in X: 4 mm

Target point Z in Z: 0 mm

Angle A to Z axis: 5.5°

Length of line L: No entry

Special feed rate F: No entry

Conclude entry:
Press the Save soft key
(There are two solutions.)

Display next solution:
Press the Next solution
soft key
(desired solution)

Press the Select solution
soft key
HEIDENHAIN MANUALplus 4110 Surface Machining Example 8.15