Measure The Workpiece; Entering Tool Compensation Values - HEIDENHAIN MANUALPLUS 4110 Manual

Tool compensation

Measure the workpiece


Run cycles "N1" to "N5"

Stop the spindle

Measure the workpiece
Example: The diameter of the finishing
allowance is 0.2 mm too large.

Entering tool compensation values


Select tool compensation:
Press the Tool/Add
correct. soft key
(Tool correct. is already
active)
No compensation values have been
entered yet. DX und DZ have the value 0.

Enter the compensation value (0.2 mm)
in the DX + field
HEIDENHAIN MANUALplus 4110 Executing Programs 11.6