Traversing The Reference Marks; Sequence For Reference Run - HEIDENHAIN MANUALPLUS 4110 Manual

Switch-on and traversing the reference marks

Traversing the reference marks

For machines with standard encoders or distance-coded encoders a reference run must be made.
Reference runs are not necessary on machines with EnDat encoders.

Sequence for reference run:

On standard encoders: A fixed reference mark is traversed. This direction of approach must be
considered.
For distance-coded encoders: The MANUALplus 4110 finds the position after a brief reference
run. (There are reference marks every 20 to 80 mm.)
Traversing the reference marks:

Pre-position the axes with
handwheels or jog keys

Press the X Reference soft
key

Press the Z Reference soft
key

Activate Cycle Start
HEIDENHAIN MANUALplus 4110 System Operation 3.7