Create Tool T2 By Copying; Copying; Assume Tool Data And Specify The Position In The Tool Manager - HEIDENHAIN MANUALPLUS 4110 Manual

Create tool T2 by copying

Copying

You can copy tools of the same type. This reduces the amount of data entry.
The tool T2 differs from T1 in its setting dimensions and tip angle. The setting dimensions are
assumed at first, and will be determined exactly later.
Roughing tool T2

Assume tool data and specify the position in the tool manager


Load the tool data T1 into
the intermediate memory:
Press the Copy soft key

Place the cursor on position
T2:
Press the arrow key

Insert the tool data from the
intermediate memory to
position T2:
Press the Insert soft key
HEIDENHAIN MANUALplus 4110 Tool Management
Cutting radius: 0.8 mm
Tool angle: 93°
Tip angle: 55°
4.5