Installing The Chassis In The Equipment Rack; Reattaching The Supplemental Bonding And Grounding Cable; Reconnecting Cables To The Replacement Chassis; Reconnecting Rp Cables - Cisco 12406 Installation And Configuration Manual

Removing and Installing the Chassis

Installing the Chassis in the Equipment Rack

Reattaching the Supplemental Bonding and Grounding Cable

Reconnecting Cables to the Replacement Chassis

Reconnecting RP Cables

Reconnecting Alarm Cards Cables

Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide
6-76
Before removing the chassis from the equipment rack, you determined how the
chassis was mounted in the rack:
Mounted directly against the rack flanges, but sitting on the optional
•
rack-mounting brackets (see
Mounted directly against the rack flanges
•
Mounted using the center-mount bracket kit (see
•
Use the same mounting arrangement and install the replacement chassis as
instructed in the "Installing the Chassis in a Rack" section on page
Reattach the bonding and grounding cable lugs to the bonding and grounding
receptacles as described in the
Connections" section on page
This section explains the following procedures:
Reconnecting RP Cables, page 6-76
•
Reconnecting Alarm Cards Cables, page 6-76
•
Reconnecting Line Card Network Interface Cables, page 6-77
•
Reconnect the cables to the RP as instructed in the
Cables" section on page
Reconnect the cables to the alarm cards as instructed in the
Card Cables" section on page
Figure 3-1 on page
"Supplemental Bonding and Grounding
3-9.
3-11.
3-13.
Chapter 6 Maintaining the Router
3-4)
Figure 3-2 on page
3-7.
"Connecting RP and Line Card
"Connecting Alarm
OL-11497-03
3-5)