Reconnecting Cables To A Line Card - Cisco 12406 Installation And Configuration Manual

Removing and Installing an RP or a Line Card

Reconnecting Cables to a Line Card

Figure 6-30 Line Card Cable-Management Brackets with Velcro Straps
Step 1
Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide
6-54
When you replace an existing line card in the line card and RP card cage, you must
reattach the line card cable-management bracket to the line card faceplate and
reconnect the network interface cables to the replacement line card as described
below.
If you have added a new line card, you must connect the additional network
interface cables to the line card and route the cables across the front of the chassis
to the vertical chassis cable-management bracket using the line card
cable-management bracket as described below and shown in
shows a generic cable management bracket and velcro strap assembly.
Velcro
strap
To reconnect network interface cables to a line card, follow these steps:
Attach an ESD-preventive strap to your wrist and connect the leash to the chassis
or to another grounded, bare metal surface.
Line card
cable management
bracket
Network
interface
cables
Chapter 6 Maintaining the Router
Figure 6-30, which
OL-11497-03