Removing and Installing a Clock and Scheduler Card, Switch Fabric Card, or Alarm Card
Removing a Switch Fabric Card
Step 1
Step 2
Step 3
Step 4
Step 5
Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide
6-62
Figure 6-34
Removing and Installing a Switch Fabric Card
CI SC O 12
00 0
GIG AB IT
SERI ES
SW ITC H
RO UT ER
1
SFC
2
Captive screw (2)
To remove a switch fabric card, see
Attach an ESD-preventive strap to your wrist and connect the leash to the chassis
or to another grounded, bare metal surface.
Loosen the captive screw on each side of the SFC faceplate.
Grasp the card ejector levers and pivot them away from the SFC faceplate.
Slide the SFC halfway out of the slot, then stop.
Touching only the metal card carrier, use your free hand to support the bottom of
the SFC.
Chapter 6
GIG AB
IT RO UT
E PR OC
ES SO R
1
3
3
Ejector lever (2)
–
–
Figure 6-34
and follow these steps:
Maintaining the Router
2
OL-11497-03