Cisco 12000 Series Router Rps; Cisco 12000 Series Router Sfcs And Cscs; Diag Command Reference - Cisco 12406 Installation And Configuration Manual

Chapter 5 Field Diagnostics for the Cisco 12000 Series Router
Note

Cisco 12000 Series Router RPs

Cisco 12000 Series Router SFCs and CSCs

diag Command Reference

OL-11497-03
Starting with Cisco IOS Release 12.0(22)S, the line card field diagnostics image
is unbundled from the main Cisco IOS image. Line card field diagnostics are now
stored and maintained as a separate image that must be available on a Flash
memory card or TFTP boot server before the diagnostics commands can be used.
Route processor and switch fabric card field diagnostics continue to be bundled
and do not need to be launched from a separate image.
The following command examples apply to GRP and PRP field diagnostics:
diag slot-number [verbose] [wait] [full] [coe]
diag slot-number previous
diag slot-number halt
The following command example applies to SFC and CSC field diagnostics:
diag slot-number [verbose]
Table 5-1 lists the diag command options and their descriptions.
Table 5-1 diag Command Reference
Command Description
slot-number Slot number of the card you want to test.
source Specifies that the source path of the line card diagnostic
image follows. This keyword must be followed by either
the tftp or flash keyword.
Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide
Using the diag Command
5-9