Chapter 6
Maintaining the Router
Step 8
Caution
Figure 6-24
Installing the Blower Module
1
HIG H SPE ED
BLO WE R
OL-11497-03
Install the blower module
Position the alignment holes on the blower module with the guide pins on the
a.
chassis and PDU.
Slide the blower over the guide pins toward the chassis until it mates with the
b.
backplane connector.
To prevent damage to the connectors, do not use excessive force when installing
the blower module.
Tighten the (4) captive screws to secure the blower module to the chassis.
c.
Lower the carrying handle to its operating position.
d.
2
3
Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide
(Figure
6-24):
Removing and Replacing a DC PDU
6-43