Installing A Line Card Cable-Management Bracket - Cisco 12406 Installation And Configuration Manual

Removing and Installing an RP or a Line Card
Caution
Step 5
Step 6
Note

Installing a Line Card Cable-Management Bracket

Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide
6-52
Handle line cards by the metal card carrier edges only; avoid touching the board
itself or any connector pins.
Go to Step 3 of the procedure "Installing an RP or Line Card" on
continue the installation of an RP or line card.
Repeat Step 2 through Step 5 for any additional card installations.
If a line card slot in the card cage is not populated with a line card, a blank line
card must be installed to avoid overheating and to ensure electromagnetic
compliance (EMC).
When you install a new line card, you must install the line card cable-management
bracket on the faceplate of the line card before connecting cables to the ports.
Figure 6-29 shows a typical line card cable-management bracket oriented and
aligned for installation on a line card in a Cisco 12006 or Cisco 12406 Router.
Figure 6-29 Line Card Cable-Management Bracket
Chapter 6 Maintaining the Router
page 6-50
For fiber-optic or
copper cable
line cards
to
OL-11497-03