Removing And Installing An Alarm Card - Cisco 12406 Installation And Configuration Manual

Chapter 6 Maintaining the Router

Removing and Installing an Alarm Card

Note
OL-11497-03
Removing and Installing a Clock and Scheduler Card, Switch Fabric Card, or Alarm Card
The two alarm cards occupy the card slots in the alarm card bay. These slots are
located on the bottom left side of the chassis, directly under the clock and
scheduler card slots. (See
alarm card.
Figure 6-35 Removing and Installing an Alarm Card
CI SC O 12
00 0
SERI ES
GIG AB IT
SW ITC H
RO UT ER
1 Alarm card
The alarm cards support OIR, so you can remove and install an alarm card while
the system remains powered up.
Procedures for removing and installing an alarm card are described in the
following sections:
Removing an Alarm Card, page 6-66
•
Installing an Alarm Card, page 6-66
•
Verifying the Installation of the Alarm Card, page 6-67
•
Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide
Figure 6-31.) Figure 6-35
GIG AB
IT RO UT
E PR OC
ES SO R
1
2
2 Captive screw (2)
shows a partially-ejected
6-65