Cisco 12406 Installation And Configuration Manual page 273

Chapter 6 Maintaining the Router
Step 9
Caution
Figure 6-14 Installing the Blower Module
HIG H SPE ED
BLO WE R
Step 10
Step 11
Step 12
OL-11497-03
Install the blower module
Position the alignment holes on the blower module with the guide pins on the
a.
chassis and PDU.
Slide the blower over the guide pins toward the chassis until it mates with the
b.
PDU connector.
To prevent damage to the connectors, do not use excessive force when installing
the blower module.
Tighten the (4) captive screws to secure the blower module to the chassis.
c.
Lower the carrying handle to its operating position.
d.
Reconnect the power cords to the PDU and secure them using their retention clips.
Plug the power cords into their AC outlets.
Power on the circuit breakers assigned to the AC outlets.
Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide
(Figure 6-14):
Removing and Replacing an AC PDU
6-29