Removing and Replacing the Blower Module
Step 1
Figure 6-5
Removing the Blower Module
1
HIG H SPE ED
BLO WE R
1
Carrying handle
Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide
6-10
Use the following procedure to remove and replace the blower module.
Remove the blower module from the chassis
Lift the blower module handle to its carrying position.
a.
Loosen the four captive screws on the blower module faceplate.
b.
Remove the blower module by grasping it on each side and pulling it straight
c.
back from the chassis.
2
(Figure
2
Captive screws (2 on each side)
Chapter 6
Maintaining the Router
6-5):
OL-11497-03