Rp Interfaces Using The Rp Leds - Cisco 12406 Installation And Configuration Manual

IOS Software Configuration for the Router

RP Interfaces Using the RP LEDs

Note
Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide
3-42
Table 3-12 LED Display Meaning and Signal Source (continued)
LED
Display Meaning
RP A valid Cisco IOS image is running.
UP
PRI The RP is enabled and recognized as the system primary.
RP A valid Cisco IOS image is running.
SEC The RP is enabled and recognized as the system
RP secondary. A valid Cisco IOS image is running.
1. The version of MBus microcode running on your system might be different.
Two types of RPs are available for Cisco 12006 and Cisco 12406 Routers: the
Gigabit Route Processor (GRP) and the Performance Route Processor (PRP).
Each of these route processor types is reviewed in the following sections:
GRP Interfaces Using the GRP LEDs, page 3-43
•
PRP Interfaces Using the PRP LEDs, page 3-44
•
When not explicitly specified, this publication uses the term route processor (RP)
to indicate either the GRP or the PRP.
The RJ-45 port LEDs on the RP indicate the following conditions:
System and RP status
•
Which Flash memory card slot is active
•
• Which Ethernet connection is in use
What is occurring on the Ethernet interface
•
The alphanumeric LED displays indicate a successful RP boot.
Chapter 3 Installing the Router
Source
RP IOS
software
RP IOS
software
RP IOS
software
OL-11497-03