Cisco 12406 Installation And Configuration Manual page 112

Installing a Router
To install the chassis in a rack, see
Move the router as close to the installation location as possible without interfering
Step 1
with the installation process.
With one person lifting from the front and one from the rear of the chassis, grasp
Step 2
the front and rear of the chassis, lift the chassis off the pallet, and position the
chassis in the rack.
A third person might be needed to assist in lifting and positioning the chassis in
Note
the rack.
Install the screws to secure the chassis to the rack:
Step 3
a.
b.
c.
d.
Repeat Step
Step 4
Do not allow the chassis to hang free until you have installed a screw in all four
Caution
hole groups (at least two screws on each side of the chassis).
Use a screwdriver to tighten all the screws.
Step 5
Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide
3-8
Look at the bottom mounting holes on the chassis rack-mount flanges. Align
one of the holes with a mounting hole in the rack.
Install one of the mounting screws provided.
On the other side of the chassis, adjust the position of the chassis so that the
same mounting hole in the bottom group of mounting holes is aligned with a
hole in the rack.
Install one of the mounting screws provided.
3a through Step
Figure 3-3 and follow these steps:
3d for additional mounting holes.
Chapter 3 Installing the Router
OL-11497-03