Connecting To A Dc Power Source - Cisco 12406 Installation And Configuration Manual

Configuration guide
Table of Contents

Advertisement

Connecting to a DC Power Source

Step 2
Step 3
Step 4
Step 5
Note
Connecting to a DC Power Source
Warning
Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide
3-32
Locate the two AC power cords and remove them from their shipping packaging.
Verify that the AC power cords shipped with the power supplies are the correct
type for your site.
If you have received the wrong type of AC power cord, contact your
Note
service representative for a replacement.
Plug the socket end of each AC power cord into a receptacle on the PDU.
(See
Figure
3-18.)
Insert the plug end of each AC power cord into the AC power source outlet.
For full redundancy, connect each AC-input power supply to an independent
power circuit with its own circuit breaker. We also recommend that you use an
uninterruptable power source (UPS) to protect against power failures at your site.
Verify that the AC power source circuit breaker servicing each of the AC-input
power supplies is switched on.
When operating your router on a single power module, the second power module
bay must have a blank filler (MAS-GSR-PWRBLANK=) installed to ensure EMI
compliance.
This section provides the procedure for connecting the router to a DC power
source.
The circuit breaker switch on the faceplate of the DC-input PEM should be in
the OFF position.
Chapter 3
Installing the Router
OL-11497-03

Advertisement

Table of Contents
loading

This manual is also suitable for:

Router cisco 12006

Table of Contents