Removing A Clock And Scheduler Card - Cisco 12406 Installation And Configuration Manual

Removing and Installing a Clock and Scheduler Card, Switch Fabric Card, or Alarm Card

Removing a Clock and Scheduler Card

Step 1
Step 2
Step 3
Step 4
Step 5
Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide
6-58
Figure 6-32 Removing and Installing a Clock and Scheduler Card
CI SC O 12
00 0
GIG AB IT SERI ES
SW ITC H
RO UT ER
C I S C O 1
G IG A B IT
1 CSC
2 Captive screw (2)
To remove a clock and scheduler card, see
Attach an ESD-preventive strap to your wrist and connect the leash to the chassis
or to another grounded, bare metal surface.
Loosen the two captive screws on each side of the CSC.
Grasp the card ejector levers and pivot them away from the CSC faceplate.
Slide the CSC halfway out of the slot, then stop.
Touching only the metal card carrier, use your free hand to support the bottom of
the CSC.
GIG AB
IT RO UT
E PR OC
ES SO R
2 0 0 0
SE RI ES
S W IT C H
R O U T E R
3 Ejector lever (2)
Figure 6-32
Chapter 6 Maintaining the Router
1
2
3
and follow these steps:
OL-11497-03