Mounting The Phone To The Wall - Cisco 7931G - Unified IP Phone VoIP Administration Manual

Chapter 3 Setting Up the Cisco Unified IP Phone

Mounting the Phone to the Wall

Caution
Step 1
Step 2
Step 3
Cisco Unified IP Phone 7931G Administration Guide for Cisco Unified Communications Manager 6.0
OL-12457-01
You can mount the Cisco Unified IP Phone on the wall using special brackets that
are available in a Cisco Unified IP Phone wall mount kit. (Wall mount kits must
be ordered separately from the phones.) You can also attach the phone to the will
without a wall mount kit. In either case, you need the following tools and parts:
Screwdriver
•
• Screws to secure the Cisco Unified IP Phone to the wall (included with the
wall mount kit
Before You Begin
To ensure that the handset attaches securely to a wall-mounted phone, remove the
handset wall hook from the handset rest, rotate the hook 180 degrees, and reinsert
the hook. Turning the hook exposes a lip on which the handset catches when the
phone is vertical. For an illustrated procedure, refer to Installing the Universal
Wall Mount Kit for the Cisco Unified IP Phone.
To mount the phone on the wall without using the wall mount kit, follow these
steps:
Use care not to damage wires or pipes located inside the wall when securing
screws to wall studs.
Procedure
Remove the footstand if it is attached to the phone.
To remove the footstand, disengage its tabs from the phone by grasping and gently
squeeze it at the top and bottom near where it attaches to the phone.
Insert two screws into a wall stud, matching them to the two screw holes on the
back of the phone.
The holes fit standard phone jack mounts.
Hang the phone on the wall.
Mounting the Phone to the Wall
3-11