Overview Of Options Configurable From A Phone - Cisco 7931G - Unified IP Phone VoIP Administration Manual

Overview of Options Configurable from a Phone

Overview of Options Configurable from a Phone
Note
Table 4-1 Settings Configurable from a Cisco Unified IP Phone
Category
DHCP settings
IP settings
TFTP settings
Cisco Unified IP Phone 7931G Administration Guide for Cisco Unified Communications Manager 6.0
4-6
Device Configuration Menu, page 4-15
•
Security Configuration Menu, page 4-35
•
The settings that you can change on a phone fall into several categories, as shown
in Table 4-1. For a detailed explanation of each setting and instructions for
changing them, see the
There are several options on the Network Configuration menu and on the Device
Configuration Menu that are for display only or that you can configure from
Cisco Unified Communications Manager. These options are also described in the
"Network Configuration Menu" section on page 4-7
Configuration Menu" section on page
Description
Dynamic Host Configuration Protocol (DHCP)
automatically assigns IP address to devices when you
connect them to the network. Cisco Unified IP Phones
enable DHCP by default.
If you do not use DHCP in your network, you can make
IP settings manually.
If you do not use DHCP to direct the phone to a TFTP
server, you must manually assign a TFTP server. You
can also assign an alternative TFTP server to use
instead of the one assigned by DHCP.
Chapter 4 Configuring Settings on the Cisco Unified IP Phone
"Network Configuration Menu" section on page
4-15.
4-7.
and the or the "Device
Network
Configuration Menu
Option
DHCP Enabled
DHCP Address
Released
Domain Name
IP Address
Subnet Mask
Default Router 1-5
DNS Server 1-5
TFTP Server 1
Alternate TFTP
TFTP Server 2
OL-12457-01