Configuring The Message Waiting Light - Cisco DPA 7630 Administration Manual

Chapter 4 Preparing the Cisco CallManager and Octel Systems

Configuring the Message Waiting Light

Configuring Message Waiting Indicators for Cisco CallManager 3.1
Step 1
Step 2
Step 3
78-11069-03
Table 4-7 End User Phones Configuration Settings
Field
Cisco CallManager 3.1
Forward Busy
Forward No Answer
Cisco CallManager 3.2
Voice Mail Profile
Forward Busy
Forward No Answer
In Cisco CallManager, you must set the option to enable the message waiting light
on Cisco IP Phones. After you configure these settings, you must record the
values and enter them on the DPA 7630/7610 (see the
Cisco CallManager" section on page
Refer to the section appropriate for the version of Cisco CallManager that you are
using in your network:
Configuring Message Waiting Indicators for Cisco CallManager 3.1,
•
page 4-13
Configuring Message Waiting Indicators Using Cisco CallManager 3.2,
•
page 4-14
You must configure these settings for each Cisco CallManager system in a
cluster, and you must stop and restart Cisco CallManager after making these
changes.
From Cisco CallManager, choose Service > Service Parameters.
From the Server drop-down list box, choose a server.
From the Services list, choose Cisco CallManager.
Cisco DPA 7630/7610 Voice Mail Gateways Administration Guide
Configuring Cisco CallManager
Description
Set to Pilot Directory Number
Set to Pilot Directory Number
Choose the profile for this directory number.
Check the Voice Mail option.
Check the Voice Mail option.
"Entering MWI for
6-10).
4-13