Digi AnywhereUSB Plus User Manual page 478

Applications
Scheduled scripts are enabled by default. To disable:
(config system schedule script 0)> enable false
(config system schedule script 0)>
4. (Optional) Provide a label for the script.
(config system schedule script 0)> label value
(config system schedule script 0)>
where value is any string. if spaces are used, enclose value within double quotes.
5. Set the mode that will be used to run the script:
(config system schedule script 0)> when mode
(config system schedule script 0)>
where mode is one of the following:
boot: The script will run once each time the device boots.
n
If boot is selected, set the action that will be taken when the script completes:
l
where action is one of the following:
o
o
o
interval: The script will start running at the specified interval, within 30 seconds after
n
the configuration change is saved. If interval is selected:
Set the interval:
l
where value is any number of weeks, days, hours, minutes, or seconds, and takes
the format number{w|d|h|m|s}.
For example, to set on_interval to ten minutes, enter either 10m or 600s:
(Optional) Configure the script to run only a single instance at a time:
l
If once is set to false, a new instance of the script will be started at every interval,
regardless of whether the script is still running from a previous interval.
AnywhereUSB Plus User Guide
Set up the AnywhereUSB Plus to automatically run your applications
(config system schedule script 0)> exit_action action
(config system schedule script 0)>
none: Action taken when the script exits.
restart: Runs the script repeatedly.
reboot: The device will reboot when the script completes.
(config system schedule script 0)> on_interval value
(config system schedule script 0)>
(config system schedule script 0)> on_interval
(config system schedule script 0)>
(config system schedule script 0)> once true
(config system schedule script 0)>
600s
478