Firmware configuration
Review AnywhereUSB Plus default settings
You can review the default settings for your AnywhereUSB Plus device by using the local WebUI or
Digi Remote Manager:
Local WebUI
1. Log into the AnywhereUSB Plus WebUI as a user with Admin access. See
interface
for details.
2. On the menu, click System > Device Configuration.
Digi Remote Manager
1. If you have not already done so, connect to your Digi Remote Manager account.
2. From the menu, click Devices to display a list of your devices.
3. Locate your device as described in
device.
4. Click the Device ID.
5. Click Settings.
The following tables list important factory default settings for the AnywhereUSB Plus.
Default interface configuration
Interface type
Wide Area Networks (WANs)
(Available only on the
AnywhereUSB Plus 8 and 24
models.)
Ethernet Network
AnywhereUSB Plus User Guide
Use Digi Remote Manager to view and manage your
Preconfigured
interfaces
Devices
n
Modem
n
n
ETH1
n
Loopback
n
n
n
Setup IP
n
Review AnywhereUSB Plus default settings
Open the web user
Default configuration
WWAN1
n
Firewall zone: External
cellular
WAN priority: Metric=3
n
modem
SIM failover after 5
n
attempts
Ethernet:
n
Firewall zone: Edge
n
DHCP client enabled
ETH1
Ethernet:
Firewall zone:
n
Loopback
Loopback
IP address: 127.0.0.1/8
n
Ethernet:
n
Firewall zone: Setup
IP address
n
ETH1
192.168.210.1/24
144
Need help?
Do you have a question about the AnywhereUSB Plus and is the answer not in the manual?