Digi One IAP Quick Start Manual

Quick Start Guide
Digi One™ IAP, Digi One™ IA, Digi
One™ IAP HAZ
1 Verify your components
Verify that you have all included equipment. If any item is missing or damaged, contact your supplier.
2 Set the DIP switch or screw-terminal pins
1. Set the serial DIP switch according to your serial device requirements (EIA-232/422/485). The pinouts are on the back of the device.
Switch settings
*If switch 4 is up, termination resister is connected.
If down, termination resistor is not connected.
© 2017 Digi International Inc.
Digi, Digi International, and the Digi logo are trademarks or registered trademarks in the United States and other countries worldwide. All other trademarks mentioned in this
document are the property of their respective owners.
Welcome to your Digi product
Get started: This guide helps you with initial product setup. Need more? Find additional
supporting material for this product at www.digi.com/products/serial-servers/digioneiapfamily.
Or connect to the online documentation by scanning this code:
Digi Technical Support: Digi offers multiple support plans to help you get the most out of your
product. For information on Technical Support plans and pricing, contact us at 877.912.3444 or
visit www.digi.com/support.
Documentation feedback: To provide feedback on this documentation, send your comments to
techcomm@digi.com.
Included equipment
DB-9 RS-232
RS-422/485
Full-duplex
2 RxD RxD+
3 TxD TxD+
7 RTS RTS+
8 CTS CTS+
5 GND GND
6 DSR RxD-
1 DCD CTS-
4 DTR RTS-
9 NA TxD-
RS-485
Half_duplex Screw term
RxD+ 6
TxD+ 3
Not used 1
Not used 8
GND 5
RxD- 7
Not used 9
Not used 2
TxD- 4