Digi AnywhereUSB Plus User Manual page 765

Routing
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Policy-based routing
Normally, a routing device determines how to route a network packet based on its destination
address. However, you can use policy-based routing to forward the packet based on other criteria,
such as the source of the packet. For example, you can configure the AnywhereUSB Plus device so
that high-priority traffic is routed through the cellular connection, while all other traffic is routed
through an Ethernet (WAN) connection.
Policy-based routing for the AnywhereUSB Plus device uses the following criteria to determine how
to route traffic:
n Firewall zone (for example, internal/outbound traffic, external/inbound traffic, or IPSec
tunnel traffic).
n Network interface (for example, the cellular connection, the WAN, or the LAN).
n IPv4 address.
n IPv6 address.
n MAC address.
n Domain.
n Protocol type (TCP, UDP, ICMP, or all).
The order of the policies is important. Routing policies are processed sequentially; as a result, if a
packet matches an earlier policy, it will be routed using that policy's rules. It will not be processed
by any subsequent rules.
Configure a routing policy
Required configuration items
The packet matching parameters. It can any combination of the following:
n
Source interface.
l
Source address. This can be a firewall zone, an interface, a single IPv4/IPv6 address or
l
network, or a MAC address.
Destination address. This can be a firewall zone, an interface, a single IPv4/IPv6 address
l
or network, or a domain.
Protocol. This can be any, tcp, udp or icmp.
l
Source port. This is only used if the protocol is set to tcp or udp.
l
Destination port. This is only used if protocol is set to tcp or udp.
l
The network interface used to reach the destination.
n
Additional configuration items
A label for the routing policy.
n
Whether packets that match this policy should be dropped when the gateway interface is
n
disconnected, rather than forwarded through other interfaces.
To configure a routing policy:
AnywhereUSB Plus User Guide
IP routing
765