Digi AnywhereUSB Plus User Manual page 201

Interfaces
o
13. Click Apply to save the configuration and apply the change.

Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the
AnywhereUSB Plus local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Change to WAN or WWAN's node in the configuration schema. For example, to disable the
default DNS test for an interface named my_wan:
(config)> network interface my_wan
(config network interface my_wan)>
4. Disable the default DNS test:
(config network interface my_wan)> surelink tests 0 enable false
(config network interface my_wan)>
5. Add a new test:
a. Add a test:
(config network interface my_wan)> add surelink tests end
(config network interface my_wan surelink tests 1)>
b. Create a label for the test:
(config network interface my_wan surelink tests 1)> label string
(config network interface my_wan surelink tests 1)>
c. if the test should apply to both IPv6 rather than IPv4, enable IPv6:
(config network interface my_wan surelink tests 1)> ipv6 true
(config network interface my_wan surelink tests 1)>
d. Set the test type:
(config network interface my_wan surelink tests 1)> test value
(config network interface my_wan surelink tests 1)>
where value is one of:
n
AnywhereUSB Plus User Guide
Down: The test will pass only if the referenced interface is down or failing its
own SureLink tests (if applicable).
ping: Uses ICMP to determine connectivity.
If ping is selected, complete the following:
Wide Area Networks (WANs)
201