Digi AnywhereUSB Plus User Manual page 433

Services
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Type system time to enter configuration mode for system time.
> config system time
(config system time)>
4. Add a new time source or modify the settings.
CAUTION! If you enable the NTP service, either disable the server configured in
system time or make sure to match the server(s) configured in service ntp
server. If you do not do one of these options, then the System time synchronization
may fail, which could result in the following error message: ntpdate[2901]: the
NTP socket is in use, exiting.
System
time setting UI Configuration
Timezone
Resynchron
ization
interval
AnywhereUSB Plus User Guide
(Optional) Set the timezone for the location of your AnywhereUSB Plus
device. The default is UTC.
(config)> system time timezone value
(config)>
Where value is the timezone using the format specified with the following
command:
(config)> system time timezone ?
Timezone: The timezone for the location of this device. This
is used to adjust the time for log
messages. It also affects actions that occur at a specific
time of day.
Format:
Africa/Abidjan
Africa/Accra
Africa/Addis_Ababa
...
(config)>
Type the frequency of the daily update.
The default is 1d (one day). Set to O (zero) for no synchronization.
(config) system time resync_interval value
(config) >
System time synchronization
433