Digi AnywhereUSB Plus User Manual page 642

System administration
c. (Optional) Reset the default password for the admin account. See
password for the admin user
Reset the device with the revert command
You can reset the device to the default configuration without removing scripts, keys, and logfiles by
using the revert command:
1. Select the device in Remote Manager and click Actions > Open Console, or log into the
AnywhereUSB Plus local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. At the config prompt, enter revert:
(config)> revert
(config)>
4. Set the password for the admin user prior to saving the changes:
(config)> auth user admin password pwd
(config)>
5. Save the configuration and apply the change.
(config)> save
Configuration saved.
>
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Custom factory default settings
You can configure your AnywhereUSB Plus device to use a custom factory default configuration file.
This way, when you erase the device's configuration, the device will reset to your custom
configuration rather than to the original factory defaults.
Required configuration items
n Custom factory default configuration (bin) file.
Configure the A nywhereUSBPlusdevice to use custom factory default settings

Web
Log into the AnywhereUSB Plus WebUI as a user with full Admin access rights.
1. Configure your AnywhereUSB Plus device to match the desired custom factory default
configuration.
AnywhereUSB Plus User Guide
Erase device configuration and reset to factory defaults
for further information.
Change the default
642