Download Print this page

Digi AnywhereUSB Plus User Manual page 265

Hide thumbs Also See for AnywhereUSB Plus:

Advertisement

Interfaces
5. Configure IPv4 settings:
a. Click to expand IPv4.
b. For Type, select Static IP address.
c. For Address, type the IPv4 address and netmask, using the format IPv4_address/netmask,
for example, 192.168.3.1/24.
d. Enable the DHCP server:
i. Click to expand DHCP server.
ii. Click to toggle on Enable.
e. Disable SureLink:
i. Click to expand SureLink.
ii. Click to toggle off Enable.
6. (Optional) Configure IPv6 settings:
a. Click to expand IPv6.
b. For Type, select IPv6 prefix delegation.
7. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the
AnywhereUSB Plus local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Set the zone to internal:
(config)> network interface eth1 zone internal
(config)>
4. Configure IPv4 settings:
a. Set the type to static:
(config)> network interface eth1 ipv4 type static
(config)>
AnywhereUSB Plus User Guide
Local Area Networks (LANs)
265

Advertisement

loading
Need help?

Need help?

Do you have a question about the AnywhereUSB Plus and is the answer not in the manual?

Subscribe to Our Youtube Channel