Digi AnywhereUSB Plus User Manual page 977

Virtual Private Networks (VPN)
Configuration
add
enable
peer
AnywhereUSB Plus User Guide
Description
Add a new WireGuard tunnel.
> config vpn wireguard add name
(config)>
Where name is the name of the new WireGuard tunnel.
For example, newtunnel1.
The WireGuard tunnel is enabled by default.
You may want to temporarily disable the tunnel while it is being set up,
for future use, or if you want to stop the tunnel while testing other
configuration changes.
To disable:
(config)> vpn wireguard name enable false
(config)>
To enable:
(config)> vpn wireguard name enable true
(config)>
a. Determine if the AnywhereUSB Plus will act as a client or server.
n If this AnywhereUSB Plus is the WireGuard client, then only
add one peer. The peer is the remote Wireguard server to
which it connects.
n If this AnywhereUSB Plus is the WireGuard server, add one or
more peers. The peer(s) are the remote WireGuard clients that
will connect to this device.
b. Create the peer(s).
(config)> vpn wireguard name add peer
(config)>
For a peer that acts as the remote Wireguard server, configure the
following settings:
[Remote] Device managed public key
n
(config vpn wireguard [name])>
Parameters
tunnel
peer
n [Remote] Public key
(config)> vpn wireguard name peer public_key
(config)>
generate
Tunnel Name (Required)
Peer (Required)
WireGuard VPN
977