Digi AnywhereUSB Plus User Manual page 281

Interfaces
f. Set the IP address or host name of the TFTP server:
(config)> network interface my_lan ipv4 dhcp_server advanced nftp_
server ip_address
(config)>
g. Set the relative path and file name of the bootfile on the TFTP server:
(config)> network interface my_lan ipv4 dhcp_server advanced bootfile
filename
(config)>
h. Enable BOOTP dynamic allocation to automatically assign an IP address to a device on
the server:
(config)> network interface my_lan ipv4 dhcp_server advanced bootp_
dynamic true
(config)>
9. See Configure DHCP options
10. See Map static IP addresses to hosts
11. Save the configuration and apply the change.
(config network interface my_lan ipv4 dhcp_server advanced static_lease
0)> save
Configuration saved.
>
12. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Map static IP addressesto hosts
You can configure the DHCP server to assign static IP addresses to specific hosts.
Required configuration items
n IP address that will be mapped to the device.
n MAC address of the device.
A dditional configuration items
A label for this instance of the static lease.
n
To map static IP addresses:

Web
AnywhereUSB Plus User Guide
CAUTION! The IP address assigned to the device is leased forever and becomes
permanently unavailable for other hosts to use.
for information about custom DHCP options.
for information about static leases.
Local Area Networks (LANs)
281