Download Print this page

Digi AnywhereUSB Plus User Manual page 327

Hide thumbs Also See for AnywhereUSB Plus:

Advertisement

Wi-Fi
3. Set the transmit power percentage for the radio:
(config)> network wifi radio phy0 tx_power value
(config)>
where value is any integer between 1 and 100 and represents the percentage of transmit
power that the Wi-Fi module should use.
4. Save the configuration and apply the change.
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure an open Wi-Fi access point
This procedure configures a Wi-Fi access point that does not require a password for client
connections.
By default, the AnywhereUSB PlusW device comes with one preconfigured access point, Digi AP. You
cannot delete default access points, but you can modify them or you can create your own access
points.
Required configuration items
n
Enable the Wi-Fi access point
n
The Service Set Identifier (SSID) for the access point.
n
Configure open security for the access point.
n
LAN/bridge assignment. Once you configure a Wi-Fi access point, you must assign the Wi-Fi
access point to a LAN interface or to a bridge. See
Configure a bridge
A dditional configuration items
Determine whether to broadcast the access point's SSID.
n
Determine whether to isolate clients connected to this access point, so that they cannot
n
communicate with each other.
The amount of time to wait before changing the group key.
n
To configure a Wi-Fi access point with no security:
Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
AnywhereUSB Plus User Guide
for more information.
Configure an open Wi-Fi access point
Configure a Local Area Network (LAN)
and
327

Advertisement

loading
Need help?

Need help?

Do you have a question about the AnywhereUSB Plus and is the answer not in the manual?