Troubleshooting
Generating a test page
5-48
NOTE: In order to assure good print quality for your jobs, the
printer purges any dog-eared or skewed sheets. In addition, the
printer may stop and issue an incorrect paper size message.
You can print the sample test page on paper stock other than
USLetter (8.5 by 11inches) or A4. While the PostScript test
image does not cover the entire page when using non-USLetter
or A4 sizes, you can still use the test page as a guide in making
the necessary alignment adjustments. Fold the test page
horizontally and vertically to check whether the folds intersect at
the center of the page.
To change the alignment values:
1. Click the Queue Management icon.
2. Right click on the queue to which the job was sent, and select
[Properties...] from the pop-up menu.
3. In the Properties window, select the [Alignment] tab.
4. Change the alignment values as needed.
5. Apply your changes by one of these methods:
•
Click [Apply] for the changes to go into effect on the next
job.
•
Click [Apply Properties Now] to apply the changes to the
current job. The system displays a message stating that
the properties were changed and that it will take a little
while to make the changes. The printer slows down or
stops, then resumes printing. You can pause the printer at
this point to check that your changes took affect.
Operator Guide