Adjusting Color Density And Balance; Printing A Test Page; Interpreting The Color Balance Test Print - Xerox 2135DX - Phaser Color Laser Printer Service Manual

Adjusting color density and balance

Over the life of the printer, colors may change. For example, reds may begin to
take on a purple cast, or blues may take on a green cast. This happens during the
normal use of a color printer and can be easily remedied by using the color
adjustment procedure described in this section
This front panel procedure involves printing a test page and adjusting the
densities and colors based on the appearance of the test page. You may need to
repeat this procedure and test your adjustments until you achieve the desired
effect.
Note At any time, you can reset the printer to the factory defaults by
selecting

Printing a Test Page

1.
Press the Menu (1, 5) keys until you see
2. Press Item (2, 6) keys and the printer prints the Color Balance test print.

Interpreting the Color Balance test print

The Color Balance test print contains
numbered images and disks that indicate
possible adjustments that can be made. You
can choose to make an adjustment to the
Black Density, the Color Balance, or the
Color Density.
The Black Density Images, numbered
-3K...0,...+3K, show a
lightness/darkness range using black
only.
The Color Balance Images, numbered
0,1,2,...12, show variations of
three-color gray. Each of these circles
contains gray with tints of other colors.
The Color Density Images, numbered
-3CMY...0,...+3CMY, show a
lightness/darkness range using three
colors (cyan, magenta, yellow).
from the Color Adjust Menu.
Color Defaults
.
Color Adjust
Service Guide 77