Performing An Emergency Power Off; Powering Off The Controller - Xerox DocuPrint 100 Operator's Manual

Managing the system
3-6

Performing an emergency power off

Disconnect the power cable from the power outlet immediately
after powering off, and contact your Xerox service
representative.
Use this procedure to switch off power quickly if any of the
following occurs:
• The equipment emits unusual odors or makes unusual
noises.
• The power cable is damaged or frayed.
• A wall panel circuit breaker, fuse, or other safety device is
switched.
• Liquid is spilled into the equipment.
• The equipment is exposed to water damage or flooding.
• Any part of the equipment is damaged.

Powering off the controller

This procedure may corrupt the DocuSP software or result in
data loss. Use it only in emergency.
1. On the DocuSP Print Services window, select [Immediate
Shutdown] from the System menu.
2. After the DocuSP Print Services window has closed, shut off
the power to the controller by one of the following methods:
• Switch off the controller power switch, located on the front
of the processor.
• Grasp the controller plug firmly and pull it from the wall
outlet.
Do not grasp the cable to pull out the plug.
• Switch off the controller power strip.
NOTE: This method powers off everything that is plugged
into the power strip, including the processor, monitor, QIC
tape drive, 36-track tape drive, and external hard disk
drive.
CAUTION
WARNING
Operator Guide