Advertisement
7.3 Camera
7.3.1 Connect from Polar Cloud
For detailed connection method，please refer to 7.2.5
After Inventor 2S printer has added to Polar Cloud account and connected
successfully (Inventor 2S printer and your computer should link to Internet by
WiFi, printer and computer do not need to connect the same WiFi signal), Then
Inventor 2S printer's camera can be used to monitor the real-time printing status.
This function is valid in FlashForge Cloud for now or later: please refer to 7.2.4 After
Inventor 2S printer has added to FlashForge Cloud account and connected
successfully (Inventor 2S printer and your computer should link to Internet by
WiFi, printer and computer do not need to connect the same WiFi signal), Then
Inventor 2S printer's camera can be used to monitor the real-time printing status.
7.3.2 Direct Connect from computer
1) Connect your Inventor 2S printer and your computer to a same WIFI signal.
2) Install and start up Firefox browser (software) on your computer, type in the
following address as the format showed below, then you can monitor the real-time
printing status by the camera.
http://192.168.1.111:8080/?action=stream
（ 192.168.1.111 is your printer's present IP address, this address must be edited
according to your printer IP address showed on printer touch screen.）
www.flashforge-usa.com
73
Advertisement
Need help?
Do you have a question about the Inventor 2S and is the answer not in the manual?