Advertisement
4-9
（4-9）After the extruder's temperature reaching 220℃, the printer will sound a beep
to prompt you to load the filament into the extruder.
4-10
（4-10） Insert the filament into the extruder at an upright angle. Then the filament will
[Cancel]
be drawn through the extruder. Do not tap
until the filament load the extruder
steadily.
4.4 Unloading Filament
4-11
(4-11) Tap
[Tool]-[Unload]
and the extruder starts heating up.
www.flashforge-usa.com
30
Advertisement
Need help?
Do you have a question about the Inventor 2S and is the answer not in the manual?