Flashforge Inventor 2S User Manual page 47

b. Bottom Solid Layer: Maximum is 30, minimum is 1.
● Infill
a. Fill Density means fill rate.
b. Fill Pattern is the pattern of filling shape which effects printing duration.
c. Combine Infill: You can select the layers for combining according to the layer
thickness. The combined thickness should not exceed 0.4mm. "Every N layers" is for
all the infills while "Every N inner layers" is only for inner infills, which generally can
save print time.
● Speed
a. Print Speed is the moving speed of the extruder. Generally, the lower the
speed is, the better print you will get. For PLA printing, 80 mm/s is recommended.
b. Travel Speed is to control the moving speed of the extruder under
non-printing Status during work. For PLA printing, 100 is recommended.
Note: Modify parameters settings to get better prints as different models need different
parameters.
● Temperature
Extruder Temperature: Recommended extruder temperature is 220℃.
Note: Different temperatures have subtle influences in prints. Please adjust the
temperature according to the condition in order to get a good print.
● Others
Pause At Heights: Allows users to pre-set a height in which the print will
suspend automatically. The function usually applied when you want to change the
filament at a certain point. Click [Edit], then you can add or remove a height.
6.2.11 File Menus
①New Project
Click [File]--[New Project]
modification on previous project, then it will inform you whether the modification
www.flashforge-usa.com
can build a blank project. If there is an unsaved
47