Advertisement
(5-2) After tapping [Yes], the extruder starts to move towards the first point and the
plate moves up and down to verify the distance between nozzle and plate.
5-3
(5-3) When it shows that the distance is too big, please unscrew corresponding nut
under platform clockwise until hearing a steady beep and the
[Verify]
button appears.
5-4
5-4
[OK]
(5-4) If the distance is appropriate, tap
to second point leveling. If still not,
please follow the prompts to adjust again till you see
[OK]
button.
5-5
(5-5) Repeat steps 2 through 4 above to complete second and third points leveling and
[Finish]
then Tap
to exit.
www.flashforge-usa.com
33
Advertisement
Need help?
Do you have a question about the Inventor 2S and is the answer not in the manual?