Flashforge Inventor 2S User Manual page 20

www.flashforge-usa.com
[Filament Check] Off:
The filament detection is turned off.
Note: Filament exhausted or interrupted
cannot be detected.The print job can still
work normally when filament is not set
into the filament cartridge.
[Door Opened Pause] On:
If printer front door is opened during
printing, door opened pause hint will pop
out on printer touch screen.
[Door Opened Pause] Off:
If printer front door is opened during
printing, door opened pause hint will not
pop out on printer touch screen.
[Power Saving Mode] On:
The power saving mode status is turned
on. If there is no operation within half an
hour, the printer will automatically shut
down. (Power saving mode will not work
in the process of printing)
[Power Saving Mode] Off
The power saving mode status is turned
off. Automatically shut down will not
work.
Turn on/off [Light Bar Control]:
light bar.
 Tap to turn on/off the
Factory Reset：Return to factory

setting.
Update: To update the firmware

version.
Back

20