Advertisement
Chapter 4: Hardware Assembly
Your Inventor 2S has been installed before leaving factory, you can start up the
Inventor 2S for printing after mounting the filament spool and completing leveling.
4.1 Filament Installation
(4-1) The filament cartridge is at the rear of Inventor 2S. Lift the cartridge out of the
Inventor 2S.
(4-2) Take out the filament and thread it through the filament detecting equipment.
(Note: The filament should feed from the bottom of the spool towards the top )
After installing the filament, put the cartridge back to the printer.
www.flashforge-usa.com
4-1
4-2
27
Black Filament Detecting
Equipment
Advertisement
Need help?
Do you have a question about the Inventor 2S and is the answer not in the manual?