Flashforge Inventor 2S User Manual page 49

● Font Size: Set the font size.
● Auto layout newly-imported model: Set Yes or No.
● Printing Window Type: Including Basic Mode and Expert Mode
● Check for Update after start up: It is used to preset if it is necessary to activate the
online automatic update function, if choose yes, every time when you open software, it
can online detect if it is a new version software, once new version found, it will
reminds users to download and install new version firmware.
6.2.12 Edit Menus
Undo
①
Allows users to undo the recent edits by the following two methods:
Method 1: Click [Edit]--[Undo].
Method 2: Press the shortcut Ctrl+Z.
② Redo
Allow users to redo the most recent edit you have undone to your model file by the
following two methods
Method 1: Click [Edit]--[Redo]
Method 2: Press the shortcut Ctrl+Y.
③Empty Undo-stack
To clean up the recorded operating steps so as to release the memory.
④ Select All
By the following two methods, you could select all models in the scene. (When
models are too small to be seen or out of viewing scope, please click
[Scale] buttons to adjust the model.)
Method 1: Click [Edit]--[Select
Method 2: Press the shortcut Ctrl+A.
⑤ Duplicate
www.flashforge-usa.com
All].
49
[Center] and