Advertisement
.
3-8
(3-8) Slightly squeeze the bottom of the lid, and remove it carefully.
(3-9) Take out the left foam, left the build plate up and take out the protective foam.
3-9
(3-9 Take out left side foam sheet. Elevate the build plate up and then take the bottom
foam sheet out.
Congratulations! You have unpacked your Inventor 2S. Next, let's move on to
hardware assembly of Inventor 2S.
www.flashforge-usa.com
26
Advertisement
Need help?
Do you have a question about the Inventor 2S and is the answer not in the manual?