Download Print this page

Flashforge Inventor 2S User Manual page 19

Hide thumbs Also See for Inventor 2S:

Advertisement

Cloud Connection: To turn on/off the
polar cloud connection.
Setup Cloud Connection: To set cloud
connection Account and PIN which have
already been registered on:
https://polar3d.com
Account: The email address of your
Cloud account.
PIN: The PIN code of your Cloud
account.
Save: To save the setting.
Back
(Note: To use polar cloud function, you
need to connect the printer to internet with
WiFi )
Extruder Calibration
To adjust the initial distance between the
extruder and the build plate by tapping
[-]and[+].
The proper distance may be one ordinary
paper's thickness.
Z: 0. 00 stands for the position where the
servo is precisely triggered.
Note: Please do this operation after
contacting with our after-sale engineer.
Turn on/off [FlashForge Cloud]:
the FlashForge
 Tap to turn on/off
Cloud Connection.
Turn on/off [Startup Sound]:
 Tap to turn on/off the sound when
restart the printer.
[Filament Check] On:
The filament detection is turned on.
Note: Filament exhausted or interrupted
will be detected. Once the filament is not
in the right place, the print job can not
work normally.
www.flashforge-usa.com
19

Advertisement

loading
Need help?

Need help?

Do you have a question about the Inventor 2S and is the answer not in the manual?

Subscribe to Our Youtube Channel