Flashforge Inventor 2S User Manual page 7

 Filament Requirements
Do not abuse the filament. Please make sure you use the FlashForge filament
or the filament from the brands accepted by FlashForge.
 Filament Storage
All polymers degrade with time. Do not unpack filament until necessary.
Filament should be stored at clean and dry conditions.
Legal Notice
All the information in this document is subject to any amendment or change
without the official authorization from FlashForge.
FLASHFORGE CORPORATION MAKES NO WARRANTY OF ANY KIND
WITH REGARD TO THIS DOCUMENT, INCLUDING, BUT NOT LIMITED
TO, THE IMPLIED WARRATIES OF MERCHANTABILITY AND FITNESS
FOR A PARTICULAR PURPOSE.
FlashForge shall not be liable for errors contained herein for incidental
consequential damages in connection with furnishing, performance or use of
this material.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This document contains proprietary information protected by copyright.
Copyright © 2017 FlashForge Corp. All Rights Reserved
www.flashforge-usa.com
7