Advertisement
4-12
、
(4-12) After the extruder reaching 220℃, the printer will sound a beep to prompt you
to unload the filament from the extruder. Press the spring presser, press down the
filament for about three seconds and gently pull the filament out.
Note: Do not pull out the filament with force as it will damage the gears. If the
melted filament has cooled down in the extruder, please repeat the steps above.
www.flashforge-usa.com
31
Advertisement
Need help?
Do you have a question about the Inventor 2S and is the answer not in the manual?