Crestron Connected Support; Setting Up Crestron Connected Support - Epson EH-QS100B User Manual

Crestron Connected Support

If you are using the Crestron Connected network monitoring and control
system, you can set up your projector for use on the system. Crestron
Connected lets you control and monitor your projector using a Web browser.
If you set the Standby Mode setting to Communication On in the
projector's Operation menu, you can control the projector even if the
projector is in standby mode (when the power is off).
For additional information on Crestron Connected, visit the Crestron Web site.
https://www.crestron.com/
To monitor devices in the system, you can use Crestron RoomView Express or
Crestron Fusion provided by Crestron. You can communicate with the help desk
and send emergency messages. See the following Web site for details.
http://www.crestron.com/getroomview
To monitor or control your projector and other various devices over a network,
you can use Crestron XiO Cloud. You can manage multiple devices from one
location. See the following Web site for details.
https://www.crestron.com/Products/Featured-Solutions/XiO-Cloud
This manual describes how to perform operations on your computer using a
Web browser.
Related Links
g
• "Setting Up Crestron Connected Support"

Setting Up Crestron Connected Support

To set up your projector for monitoring and control using a Crestron Connected
system, make sure your computer and projector are connected to the network.
a
Press the [Menu] button, select the Network menu, and press [Enter].
b
Select Network Settings and press [Enter].
p.111
c
Select the Projector Control menu and press [Enter].
d
Set the Crestron Connected setting to On to allow the projector to be
detected.
• If no password has been set, a screen prompting you to set a
password is displayed before you can set Crestron Connected to
On. Follow the on-screen instructions to set the password.
• To enable the Crestron XiO Cloud service, set Crestron XiO
Cloud to On.
e
When you finish selecting settings, go back to the Network Settings
screen, select Set, and follow the on-screen instructions to save your
settings and exit the menus.
f
Turn off the projector, and then turn it on again to enable the setting.
111