Crestron Connected Support; Setting Up Crestron Connected Support - Epson EV-110 User Manual

Crestron Connected Support

If you are using the Crestron Connected network monitoring and control
system, you can set up your projector for use on the system. Crestron
Connected lets you control and monitor your projector using a Web browser.
• You cannot use the Message Broadcasting feature in Epson Projector
Management when you use Crestron Connected.
a
• Under the following conditions, you can control the projector even if
the projector is in standby mode (when the power is off).
• When the Standby Mode setting is set to Communication On
s Extended > Standby Mode > Standby Mode
• When connecting to a wireless LAN with the Connection Mode
setting set to Advanced or connecting to a wired LAN
s Network > Network Configuration > Wireless LAN >
Connection Mode
For additional information on Crestron Connected, visit the Crestron Web
site.
https://www.crestron.com/products/line/crestron-connected
To monitor devices in the system, you can use Crestron RoomView Express
or Crestron Fusion provided by Crestron. You can communicate with the
help desk and send emergency messages. See the following Web site for
details.
http://www.crestron.com/getroomview
This manual describes how to perform operations on your computer using a
Web browser.
g g Related Links
• "Setting Up Crestron Connected Support"
• "Projector Setup Settings - Extended Menu"

Setting Up Crestron Connected Support

To set up your projector for monitoring and control using a Crestron
Connected system, make sure your computer and projector are connected to
the network.
p.110
p.126
If you are connecting wirelessly, set up the projector using the Advanced
network connection mode.
a Press the [Menu] button, select the Network menu, and press [Enter].
Select Network Configuration and press [Enter].
b
c Select the Others menu and press [Enter].
d Set the Crestron Connected setting to On to allow the projector to be
detected.
e When you have finished selecting settings, select Complete and follow
the on-screen instructions to save your settings and exit the menus.
f Turn off the projector, and then turn it on again to enable the setting.
g Start your Web browser on a computer or device connected to the
network.
h Go to the Epson Web Control screen by entering the projector's IP
address into the browser's address box.
110