Transferring Settings From A Computer - Epson EH-QS100B User Manual

Copying Menu Settings Between Projectors (Batch Setup)
e
Remove the USB flash drive.
The file name for the batch setup file is PJCONFDATA.bin. If you
need to change the file name, add text after PJCONFDATA using
only alphanumeric characters. If you change the PJCONFDATA
section of the file name, the projector may not be able to recognize
the file correctly.
f
Disconnect the power cord from the projector to which you want to copy
settings, and check that all of the projector's indicators have turned off.
g
Connect the USB flash drive containing the saved batch setup file to the
projector's USB-A port.
h
Hold down the [Menu] button on the remote control or the control panel
and connect the power cord to the projector.
i
When all of the projector's indicators turn on, release the [Menu] button.
(The indicators remain on for approximately 75 seconds.)
When all of the indicators start flashing, the settings are being written.
When writing is finished, the projector turns off.
Caution
Do not disconnect the power cord or the USB flash drive from the projector
while the file is being written. If the power cord or USB flash drive is
disconnected, the projector may not start correctly.
j
Remove the USB flash drive.

Transferring Settings From a Computer

You can copy menu settings from one projector to another of the same model by
connecting the computer and projector with a USB cable.
• You can use this batch setup method with the following operating
system versions:
• Windows 10 and later
• macOS 10.13.x and later
• You can also use this batch setup method from the projector's menu.
a
Disconnect the power cord from the projector, and check that all of the
projector's indicators have turned off.
b
Connect a USB cable to the computer's USB port and to the projector's
USB-B port.
c
Hold down the [Esc] button on the remote control or the control panel
and connect the power cord to the projector.
d
When all of the projector's indicators turn on, release the [Esc] button.
The computer recognizes the projector as a removable disk.
e
Open the removable disk icon or folder, and save the batch setup file to the
computer.
The file name for the batch setup file is PJCONFDATA.bin. If you
need to change the file name, add text after PJCONFDATA using
only alphanumeric characters. If you change the PJCONFDATA
section of the file name, the projector may not be able to recognize
the file correctly.
138